[wat to use to cut m fenders??] - ATV Riders Forums - Honda, Yamaha, Suzuki, Kawasaki, Polaris, CanAm, Arctic Cat, Kymco ATVs

Pages:1

wat to use to cut m fenders??
(Click here to view the original thread with full colors/images)

Posted by: Z400rider24

Hey just wondering what i should use to cut my fenders??? razorblade, dremel, sheet rock knife??? Let me know asap cause i would like to get them cut this weekend

Posted by: member

i used a hack saw .. but cut an inch away from where you want it then just spend an hour or so sanding it to where you want it.. thats what i did

Posted by: JDiablo

i used a sheetrock knife and a dremel but i didnt like the dremel i couldn't get the lines straight lol....after your done sand off the edges with like 1500 or 2000 grit sand paper and when your done with that go over the edges with a torch or lighter to get the edge back to the normal color but idk if you have to only if you have like red or black plastics,i would still do it though

Posted by: EvilJester400EX

Jigsaw.

Posted by: QuAdEr 317

Jigsaw than finish it up by sanding it to where you want

Posted by: Jumbo747

i used a handsaw & marked what i wanted to cut before with a magic marker

Posted by: YamaWarr0121

mark with a dry erase marker and electrical tape or maskin tape and cut with a dremel or jigsaw i prefer a dremel if you have them they ar very easy to work wiht compared to a hand tool or a jig

Posted by: Dunesurfer

The first set I cut I used a grinder, the second I used a jigsaw with a fine tooth blad and it cut them like butter and was easy to control. I put tape where I wanted to cut them off and just followed the edge of the tape line.