[Powder Coating?] - ATV Riders Forums - Honda, Yamaha, Suzuki, Kawasaki, Polaris, CanAm, Arctic Cat, Kymco ATVs

Pages:1

Powder Coating?
(Click here to view the original thread with full colors/images)

Posted by: 250EXstud

CAn someone give me a rough idea on how much it would cost to do a frame, A arms, Subframe,maybe swing arm? I am thinking about getting all this on my 400 in black. I may do my rims too if i can't get hypers? Does this stuff chip or scratch? And how hard is it to totally strip a bike. That is the part i am worried about.

Posted by: gimp419

Usually when you take it to the powder coating shop they can sand blast it for you for an additional cost. For all that you are wanting done expect to pay at least $150. As far as holding up, there is nothing that takes a beating and shines through it better than powder coating. It's a lot cheaper in the long run, cause it will usually last 3 or 4 years.

Posted by: 250EXstud

What colors should I get? I was thinking black. Maybe a yellow to math the plastic, but i don't know. Anyone else got any ideas