[ATV Four Play A-arms and hose issues] - ATV Riders Forums - Honda, Yamaha, Suzuki, Kawasaki, Polaris, CanAm, Arctic Cat, Kymco ATVs

Pages:1

ATV Four Play A-arms and hose issues
(Click here to view the original thread with full colors/images)

Posted by: p411m

I have ATV FourPlay a-arms up from and am having a problem with the bottom hose from the radiator that goes to the bottom water pump inlet rubbing against the tie-rod...any suggestions? Pics of your setup? Thanks in advance!

Posted by: A.Kersey321

Could you try cutting a little off the end of the hose then stretch it back to the radiator, this should pull it to be more straight.

Posted by: T@AFP

You can roll the hose in towards the pivot points of the A arms too. This will allow you a little more clearance. It is a tight fit in there.

Posted by: JIM GRACE

rubbings racing. lol i have seen them cut with an extension but
we leave ours alone and there fine. it would be sweet if cv4 would
come out with better ones and colors

Posted by: zach R 7x

we ran FOUR PLAYS suspension this year and had no problems . i did cut a 1" hose in two and zipped tied it around that particular section of hose ,so it did not rub .