[Interchangeability CR 250, TRX 250] - ATV Riders Forums - Honda, Yamaha, Suzuki, Kawasaki, Polaris, CanAm, Arctic Cat, Kymco ATVs

Pages:1

Interchangeability CR 250, TRX 250
(Click here to view the original thread with full colors/images)

Posted by: Honda 250r 001

Alright i figure its about time we start learning about the Cr motor. Are any of the parts that you guys know of the same? I wonder about the crank, right case half, tranny and clutch.

Anyone got anything they know will work or have heard will work?

Posted by: thedeatons

The 1985-2001 CR250 connecting rod is the same as the 1986 ATC/TRX250R "short rod". Nik's Pro-X makes the replacement rod kit, sold through Rocky Mt. ATV among others.

The CR250 crankshaft will NOT work on the TRX250R, one half is different because of the counterbalancer. This also means the CR250 cases will NOT work on the TRX250R, because the CR250 has NO counterbalancer. (Meaning a LOT of vibration in the quad chassis, just like installing a CR500 engine in the quad chassis).

Posted by: Honda 250r 001

isint the cr 250 rod like titanium or something? lighter than the standard 250r rod?

Posted by: thedeatons

Not the 1985-2001 CR250. It is the same rod as what came in the 1986 ATC/TRX250R (short rod dimensions).

Posted by: Honda 250r 001

ok thats pretty good to know, but what about the clutch? any tranny gears? such as the countershaft 3rd that always seems to be bad on the 250r?

Posted by: Rich250RRacer

The clutch in a 250R is much smaller in diameter than the CR250, which really doesn't make sense to me. It may be closer to a 125. I don't think anything in the transmission except for misc. washers and bolts will interchange. If any internals will fit, it would probably be from 84-91 CR models, which the 250R engine was based off of.

Posted by: voodoochassis

88-91 cr250 cylinder will work with special spacer and studs and block off powervalve. www.ftzracing.com