[Need a Dimension. Rear Case bushing on YZ400-450F] - ATV Riders Forums - Honda, Yamaha, Suzuki, Kawasaki, Polaris, CanAm, Arctic Cat, Kymco ATVs

Pages:1

Need a Dimension. Rear Case bushing on YZ400-450F
(Click here to view the original thread with full colors/images)

Posted by: Groves187

I am looking for the dimensions for the case bushing that the pivot bolt runs threw. I dont have any bushing in my motor to measure of off so I figured I would put up a post and see if anyone had a motor out they could measure them from. The only Dimension i need from this bushing is the lip that sticks out of the cases.

Here is a link to a parts finder that shows what i am talking about, They call it a "Collar" The # on the page is 23.

http://www.yamahaoftroy.com/fiche_section_detail.asp

Thanks, Nick

Posted by: ss440ex

Mark Vette,
Do you happen to have an engine we can get a pic of and some measurements off of?
The rear bushing area where the pivot bolt goes through?
Need measurements of the OEM bushings.
Thanks.

Posted by: Groves187

Al, I sent him a PM with no Reply, So I posted it also.

Nick

Posted by: markvette

sorry been busy, kids birthday party today. ok the bushing sticks out .135 now that is not from the small recess the bushing fits in that is off the outside edge of the case. hope this is what you need.

Mark

Posted by: ss440ex

I believe that is what he is looking for!!!

Thanks Mark.

Al

Posted by: Groves187

Thanks A lot Mark. Thats what I was looking for.

Nick