[Cernics start button HELP] - ATV Riders Forums - Honda, Yamaha, Suzuki, Kawasaki, Polaris, CanAm, Arctic Cat, Kymco ATVs

Pages:1

Cernics start button HELP
(Click here to view the original thread with full colors/images)

Posted by: QIKLTR

i just installed cernics start button and now my tether kill switch wont work. i have my tether wired to my rooll over kill switch box and it has always worked but now after installing the start button it wont work. i cant really understand how the problem would even be related. any suggestions would be greatly appreciated.

Posted by: CdaleXtreme

On the Kill switch you purchased, you will find a wire that comes out of the plug, and then loops back into the plug. Wire your Kill switch into that, and ground the 3rd wire properly, and you will be good to go.

Posted by: Trx250rider86

yup thats what i did, no problems yet other than my gunner kill switch being defective and dieing on me before a race, but cernics replaced my gunner with a Pingle that i have yet to put on,

thanks cernics!

Posted by: QIKLTR

sweet thanks guys

Posted by: QIKLTR

will that work with a pro armor kill switch or does it have to be a pingel...arent they different?

Posted by: Trx250rider86

no its doesnt have to be a pingle, i dont know how the pro armor one is so i cant tell you, i would think they are all mostly the same

Posted by: hondaracer31

I think the Pingle is "normally closed". The Pro Armor is "normally open".

Posted by: QIKLTR

yeah thats what i was getting at honda...i gotta get it figured out i gotta make a 5 hr drive to my next race

Posted by: CdaleXtreme

It must be a Normally Close Kill Switch.

Posted by: QIKLTR

i got it figured out. it was the killswitch itself. made it to the race and finished 9th. 3hrs sleep plus 5hr drive and then 2hr race makes for a poor finish. i wont make that misstake again!