[Looking to install 350x swing arm] - ATV Riders Forums - Honda, Yamaha, Suzuki, Kawasaki, Polaris, CanAm, Arctic Cat, Kymco ATVs

Pages:1

Looking to install 350x swing arm
(Click here to view the original thread with full colors/images)

Posted by: dabomb_350x

I am looking ot install a '86 350x swingarm. Have soem question from looking at other post. Seem like everone is off setting the swingarm to one side when spacing it. Does the chain still ride on the chain slide? This is what my plans are 350X swing arm , RAD taper bearing carrier, 350x brake caliper. I wan to keep my Durablue 2+2 300ex axle and anti fabe hub. Can I go withthis set up? When I install a 350x motor in the 250x frame I had not issues with the cahin line alignment.

Posted by: Tri-valleyracin

it will boilt up with more washers on the right side and less on the left. its a great set up. yes u can use the 300ex axle and antifade. i have a lsr carrier on my 300 and the chain is fine. it will run on the slidder but not completely.

Posted by: Kawboyz beware

when I did mine I had 2 washers on the chain side and 5 on the other. also honda does not make a swingarm pivor sleeve , also do not run a 350x shock, I made a bracket to install a raptor rear shock

Posted by: lil rippers dad

why not run the 350 x shock? we run ours and it works great, sets the bike real low and corners good

Posted by: Kawboyz beware

I thought the suspension action was a bit harsh. I switched to a raptor shock with the 350x swinger

Posted by: 2muchquad

the 350x shock is super stiff.

Posted by: Tri-valleyracin

quote:
Originally posted by 2muchquad
the 350x shock is super stiff.

but for mx racing its great. its just the spring. i changed out the spring to a 450r one and its was to soft for me but some one lighter it would be great. i have the hole shock set up right now is any one want to buy it. make an offer