[Steering stem bushing] - ATV Riders Forums - Honda, Yamaha, Suzuki, Kawasaki, Polaris, CanAm, Arctic Cat, Kymco ATVs

Pages:1

Steering stem bushing
(Click here to view the original thread with full colors/images)

Posted by: Donkey1

How long does it take to replace the bushing. Does it take any special tools

Posted by: Scro

All you will need is a large socket that will fit the outer edge of the bearing. Then just tap it with a hammer.

Posted by: Crazy Diamond

On a Z you will need to remove the oil reservoir. If I remember correctly! Someone correct me if I am wrong. But I think when I changed mine I had to take it out so that the ears on the stem cleared enough to get past the bushing. You need to get the stem out past the bushing in order to remove it. And before its out far enough you hit the tank and can't avoid it!

Posted by: jonboy

Yeah on mine I just took the bolts out of the tank to move it back a little. Once the stem was up out of the way I did like SCRO said and used a socket to pop the old one out. Then I just set the new one on the stem and seated it a little and drove it in by hitting the top of the stem with a rubber mallet. Worked OK for me.

Posted by: Donkey1

Thanks. It does not sound to bad.

Posted by: erac4019

When I did mine I left the plastic on and just unbolted the tierods and took the bolts out of the radiator and oil tank so I could pull the stem up. I dont remember but I think there was enough slack in the throttle cable and clutch cables to just pull up on the stem to replace the bushings.