[250R Key] - ATV Riders Forums - Honda, Yamaha, Suzuki, Kawasaki, Polaris, CanAm, Arctic Cat, Kymco ATVs

Pages:1

250R Key
(Click here to view the original thread with full colors/images)

Posted by: J.B.

I recently purchased a 89 250r key, switch and wiring for my 88 250r. The switch has 2 wires on it, a red (male plug) and a black (female plug). Upon going to install it, the only 2 unpluged wires i found were both female.

one appeared to be black with a red stripe and one green. The green looked to be a ground.

Any idea how to hook this up or am i out of luck?

Thanks
Joe

Posted by: 86 Quad R

check your pm's

Posted by: J.B.

Replied. Anyone else know? Or anyone with a 88r, could you trace your 2 key wires for me if your hoods off?

Posted by: 2StrokeFreak

You dont need to have the hood off to find the connection. Follow the harness down the upper left frame rail near the fuel valve. There is a square rubber dust cover with a few connectors in it. The two female connectors in the harness are for the key switch. Key switch should have male connectors.

Posted by: J.B.

I was told it was an 89 key and switch and its one male and one female.

Posted by: deathman53

why not meter it out and you want to make sure its normally closed(continuity with key out of switch) and put a new end on the wire, very easily done. trx250r key switches are no longer available, I use crf50 key switches, nearly identical to 250r key switches.