[Our LTR450 Photos] - ATV Riders Forums - Honda, Yamaha, Suzuki, Kawasaki, Polaris, CanAm, Arctic Cat, Kymco ATVs

Pages:1

Our LTR450 Photos
(Click here to view the original thread with full colors/images)

Posted by: FUELATV

Here are some shots of our new LTR450.

http://i35.photobucket.com/albums/d169/FUELATV2005/BAILEYLTR4507.jpg

http://i35.photobucket.com/albums/d169/FUELATV2005/BAILEYEASTERBUNNY34.jpg

http://i35.photobucket.com/albums/d169/FUELATV2005/BAILEYEASTERBUNNY33.jpg

http://i35.photobucket.com/albums/d169/FUELATV2005/BAILEYEASTERBUNNY32.jpg

http://i35.photobucket.com/albums/d169/FUELATV2005/LTR450.jpg

Posted by: spudss

NICE!!!!!!!!!!!! I like the no graphix look.. And where did you get the quadtech seat.. I want one.. Let me know about that..

Posted by: FUELATV

Thanks....I got the cover direct from QuadTech. I am going to install graphics. Just waiting to see what comes out.

Posted by: spudss

What was the cost of the seat cover if you dont mind me asking...

Posted by: FUELATV

It was $110.00. Too much money IMO but i like the look and it shipped same day. I am a sucker i guess.

Posted by: spudss

how is it compared to stock.. Is it alot softer??

Posted by: Tom TRX250R

That is the best LT450 I have seen! I like the clean look of it with no graphics!!

Posted by: ACEOUTDOOR

What did you use to get ALL of the glue/adhesive off the plastic after removing the # backrounds?

Posted by: walty

use spray carb cleaner...i will come off in seconds!!!

Posted by: atvracer9m

thats schit its sick .. i want a zuke reall bad now

Posted by: FUELATV

Thanks the bike is really starting to come together. Now time for the i-shock long travel setup....
SPUDSS - this is just a seat cover it uses the stock foam. So it is not softer.
I would not use carb cleaner as it might dull the finish on the plastics. I just peeled them off. VERY SLOW and VERY CAREFULL. I Then used simple green to remove any adhesive.

Posted by: walty

quote:
Originally posted by walty
use spray carb cleaner...i will come off in seconds!!!

done millions of times....dont let it soak too long!!!

if you want to clean something and it dont come off...use carb cleaner!!!!!!!!!!!!

so good..it should be in tips and tricks!!!give it a try
i took ALL of my canadian warning sticker of my ltr that way...after peeling the label,use carb cleaner to wipe of the glue

Posted by: TC440EX

Nice looking Quad. Who's stem and what bend are the bars?

Posted by: FUELATV

THANKS..... the stem is by us FUELATV, and the bars are TAG cr high bend. The stem is +1 anti-vibe. The TAG bars are about a 1/4 inch shorter then stock. So with this set up your bars will be abou 3/4 inch higher then stock.

Posted by: TC440EX

How much is the stem?