[wont start,, need help or manual] - ATV Riders Forums - Honda, Yamaha, Suzuki, Kawasaki, Polaris, CanAm, Arctic Cat, Kymco ATVs

Pages:1

wont start,, need help or manual
(Click here to view the original thread with full colors/images)

Posted by: bobby bo

i started the bike to warm it up. started right up,, let it warm up. turned off. now it wont start. i check the carb thats good, the plug is wet. spark looks weak but i dont have another 250r to compare. cleaned the stator and flywheel. has new plug. after a few kicks the plug is very wet. can that be broken reeds?? oh i swapped cdi boxes also... any help would be great. thanks

Posted by: 250R-Dee

Go to everything2stroke.com and download the manual from the manuals section.

Posted by: zedicus00

turn the gas off pull the plug out and kick it a bunch..... then put a new plug in an it should go. sounds like u seriously wet fouled it. dont idle around on a 2 stroke then shut it off, ride it an romp on it, after its a lil warm.

Posted by: bobby bo

thanks for the manual.. the plug is brand new,, its white..

Posted by: bobby bo

ok i did the tests on the electrical.. i ohmed out the coil from the connector on the back to the boot nothing, removed boot still nothing. the book says its supposed to have around 7 ohms. has anyone ohmed theirs out and got the proper reading??

Posted by: Dave83

You got your ohmmeter on the correct range.I did that once,ohm everything and would get nothing on the coil.I had to go to a different range on the meter.

Posted by: bobby bo

also are the reeds suppossed to be close, no gap. mine have a gap on both.

Posted by: bobby bo

quote:
Originally posted by Dave83
You got your ohmmeter on the correct range.I did that once,ohm everything and would get nothing on the coil.I had to go to a different range on the meter.

your right,, i reread it, i was looking for 3-5 ohms,, where i need to look for 3-5k ohms,, thanks