[V-Force 3 reeds?] - ATV Riders Forums - Honda, Yamaha, Suzuki, Kawasaki, Polaris, CanAm, Arctic Cat, Kymco ATVs

Pages:1

V-Force 3 reeds?
(Click here to view the original thread with full colors/images)

Posted by: pharit

Well this work on our cylinders i don;t see them under the listings for a 250r but i see them for the cr 250 just wondering if they'll work or what

Posted by: chia355

Don't do it , I was going to do that until I called Moto Tassinari and they said Vforce 3s dont hold up from a CR250 , and as of now theyve side tabled them for the TRX 250R until they can engineer them better

Posted by: zedicus00

they work fine for me. u hav to port the piss out of the inside of the reed flange though or it blocks a lot of air. the petals are actually thicker on the v-force 3 an the engine builder i talked to said the moto tassarini said not to use them on a 250r bucus it would weeken throttle responce and low end power a lil bit. i hav a mid-top setup though thas y i went with the v-force 3 specifically.